Titanium Dioxide in Korean Sunscreen Rules: 90.0% Assay vs Zinc Oxide's 99.5%

Published October 29, 2026 · SJ AI Studio

The Korean codex gives titanium dioxide an assay floor of 90.0% (on the dried basis), much lower than the 99.5% it sets for zinc oxide, the other mineral sunscreen filter. Both monographs sit in Annex 4, the UV protection section of the codex published by the Ministry of Food and Drug Safety (MFDS).

The two minerals are also the subject of a separate test in Annex 10: an alternative method for measuring their content in finished sunscreens. This page puts the numbers side by side.

Everything below rests on two Korean legal texts. The titanium dioxide monograph itself — the 90.0% assay, the 5 mg water-soluble cap, the Annex 10 content test — is printed in the MFDS notice "Standards and Test Methods for Functional Cosmetics" (기능성화장품 기준 및 시험방법), MFDS Notice No. 2025-89, amended 16 December 2025, the text its own general annex calls the Korean Functional Cosmetics Codex (KFCC). What a mineral sunscreen may be *sold as* is settled in a different place, Article 2 of the Enforcement Rule of the Cosmetics Act. Both were read in Korean. Korean statutes and notices carry no copyright (Copyright Act, Article 7), so the wording is quoted rather than paraphrased. No product, price or ranking appears here.

Which functional claim type does titanium dioxide belong to?

In Korea a mineral sunscreen is not registered as a "sunscreen". It is registered as a functional cosmetic of one named type, and the type titanium dioxide belongs to is item 5, UV protection, in the closed list of Article 2 of the Enforcement Rule of the Cosmetics Act. The Korean text reads:

자외선을 차단 또는 산란시켜 자외선으로부터 피부를 보호하는 기능을 가진 화장품

In English: item 5 of Article 2 covers a cosmetic that protects the skin from ultraviolet rays by blocking or scattering them.

The wording covers products that block or scatter ultraviolet rays. It does not mention SPF or PA ratings; those are set in other notices not read for this page.

What does the titanium dioxide monograph set?

Annex 4 of the codex includes a raw-ingredient monograph for titanium dioxide. Its values, copied from the Korean text:

Item in the monographWhat the codex states
Formula and weightTiO2, 79.88
Other name in the codex이산화티탄 (a Korean-language alias)
Assay90.0% or more, when dried
ReactionNeutral
Water-soluble substances5 mg or less
Lead50 ppm or less
Arsenic10 ppm or less
Loss on drying2.5% or less

How should you read the terms in the titanium dioxide monograph?

Mineral Filter Assay Floors

The titanium dioxide entry is written the way the whole codex is written: a short Korean test label, a limit, and nothing that explains either. The middle column below supplies that explanation in general terms — it is a gloss on the test, not a statement by the codex — and the right column repeats the value exactly as the MFDS printed it for this ingredient.

Term in the monographGeneral meaning of the testValue in this monograph
Formula and weightThe chemical formula and molecular weight that identify the compound.TiO2, 79.88
AssayThe test that measures how much of the named substance a sample contains, usually as a percentage.90.0% or more, when dried
ReactionWhether a solution of the substance is acidic, neutral or alkaline.Neutral
Water-soluble substancesMaterial that dissolves in water, limited as an impurity.5 mg or less
LeadA limit test for lead as an impurity, in ppm.50 ppm or less
ArsenicA limit test for arsenic as an impurity, in ppm.10 ppm or less
Loss on dryingThe share of the sample's mass lost when it is dried under stated conditions, mostly water and other volatile matter.2.5% or less

Read as a group, the titanium dioxide lines point in two directions. The 5 mg of water-soluble substances and the 50 ppm of lead are ceilings — the most that may be present. The 90.0% assay is a floor — the least that must be. None of them describes a finished sunscreen, which is tested against its own label and its own monograph; that is exactly why the codex carries the separate Annex 10 method set out below.

How does the titanium dioxide assay compare with other codex ingredients?

Titanium Dioxide Codex Values

Still the same source, the MFDS codex, and still raw ingredients rather than products. Ordering the monographs read for this site by the floor each one sets shows where titanium dioxide’s 90.0% actually falls:

IngredientAnnexAssay as printed in the monograph
Salicylic acidAnnex 899.5% or more
Zinc oxideAnnex 499.5% or more, after ignition
AdenosineAnnex 399.0% or more
BiotinAnnex 998.5-101.0%, on the dried basis
ArbutinAnnex 298.0% or more
Ascorbyl glucosideAnnex 298.0% or more
DexpanthenolAnnex 998.0-102.0%, on the anhydrous basis
L-mentholAnnex 998.0-101.0%
NiacinamideAnnex 298.0% or more, when dried
Ascorbyl tetraisopalmitateAnnex 295.0% or more
Ethyl ascorbyl etherAnnex 295.0% or more, when dried
PEG-retinamideAnnex 395.0% or more
Titanium dioxide (this page)Annex 490.0% or more, when dried
Zinc pyrithioneAnnex 990.0-101.0%, when dried

In the MFDS codex, titanium dioxide ranks 13 of 14 by the lower assay limit among the monographs read for this site, with 12 entries above it and 1 tied with it. Titanium dioxide's floor of 90.0% is the lowest among the raw monographs read for this site, shared only with zinc pyrithione.

How do titanium dioxide and zinc oxide compare in the codex?

Same source, the MFDS codex. The two mineral filters, side by side:

ItemTitanium dioxideZinc oxide
Formula and weightTiO2, 79.88ZnO, 81.38
Assay90.0% or more, when dried99.5% or more, after ignition
Water-soluble substances5 mg or less0.1% or less
Lead50 ppm or less40 ppm or less
Arsenic10 ppm or less2 ppm or less
Loss2.5% or less on drying1.0% or less on ignition

The columns are not directly comparable line by line, because the loss test is different for each (drying against ignition) and the water-soluble line is printed in mg for one and as a percentage for the other. What is plain is that zinc oxide's assay floor is more than nine points higher and its arsenic cap is five times tighter.

Annex 10 adds an alternative content test. Section II.2 of the general tests describes an alternative method for measuring titanium dioxide and zinc oxide in finished UV products sold in Korea. The conditions printed in the codex are: a xenon arc lamp covering 290 to 400 nm, an application of 2.0 mg per square centimetre (or 2.0 microlitres per square centimetre), 15 minutes at room temperature before measuring, and the mean of three readings. A standard is set from the mean of at least three test results for each of three lots.

Is there a finished-product monograph for titanium dioxide?

The Annex 4 monograph covers the raw titanium dioxide. The codex records no finished-product monograph for it in the extract read for this page; instead Annex 10 offers the alternative content test for finished products described above, which applies to this ingredient and zinc oxide together.

titanium dioxide label checklist

How to check a titanium dioxide claim yourself

SPF and PA ratings. They are set in other notices not read for this page.

Every functional type and its codex ingredients are grouped in our K-beauty functional ingredient index.

Sources and how to check

Korean Legal Sources

Questions readers ask about Titanium Dioxide in Korean Sunscreen Rules

What assay does the Korean codex require for titanium dioxide?

The monograph in Annex 4 of the MFDS codex (Notice No. 2025-89) states 90.0% or more, when dried.

How does that compare with zinc oxide?

The same codex states 99.5% or more, after ignition, for zinc oxide.

What is the Annex 10 test?

An alternative method for measuring titanium dioxide and zinc oxide content in finished UV products, using a xenon arc lamp from 290 to 400 nm and three readings averaged.

Does the codex give SPF values?

No. SPF and PA labelling is set in other notices.

Is there a finished-product monograph?

The extract read for this page records none in Annex 4; Annex 10 provides a content test instead.

Related articles